Never stop talking " STOP the Gaza Genocide "
  • Lesson.No : 24
  • 00:04:56

  • CALCULATE METRIC FEEDS AND SPEEDS FOR CNC MILL OR LATHE

  • Play

Course Lessons

  1. 1- INTRODUCTION TO CNC MILL PROGRAMMING
  2. 2- BASICS OF A CUTTER PATH ON A CNC MILL
  3. 3- G1 LINEAR MOVE AND G2 CLOCKWISE ARCS
  4. 4- HOW TO USE A G3 COUNTERCLOCKWISE ARC IN A CNC MILL PROGRAM
  5. 5- DO YOU KNOW THE DIFFERENCE BETWEEN CLIMB CUTTING AND CONVENTIONAL CUTTING?
  6. 6- HOW TO USE CUTTER COMPENSATION ON A CNC MILL
  7. 7- HOW TO USE TOOL OFFSETS AND WORK OFFSETS IN A CNC PROGRAM
  8. 8- WHAT ARE I'S AND J'S USED FOR IN A CNC MILL PROGRAM?
  9. 9- ARE YOU IN ABSOLUTE OR INCREMENTAL MODE?
  10. 10- COMMON M-CODES USED IN A CNC MILL PROGRAM
  11. 11- CANNED CYCLES FOR DRILLING AND TAPPING FOR A CNC MILL
  12. 12- HOW TO CALCULATE FEEDS AND SPEEDS FOR A CNC MILL
  13. 13- HOW TO USE AN M98 TO CALL SUB PROGRAMS ON A CNC MILL
  14. 14- HOW TO USE A G10 COMMAND TO LOAD WORK COORDINATES FROM YOUR PROGRAM
  15. 15- ROTATE YOUR GEOMETRY USING THE G68 COMMAND
  16. 16- HOW TO USE GOOD PROGRAM FORMAT IN YOUR CNC MILL PROGRAM
  17. 17- HOW TO USE A BLOCK SKIP AND GOTO COMMANDS
  18. 18- CALCULATING A BOLT HOLE CIRCLE
  19. 19- WHILE DO LOOP IN A CNC MILL PROGRAM
  20. 20- CIRCLE MILLING USING VARIABLES
  21. 21- HAND WRITE A CIRCLE MILLING PROGRAM FOR A CNC MILL
  22. 22- CNC MILL PROGRAMMING A G68 COMMAND ON A VF3 HAAS MILL
  23. 23- DRILLING STEEL AT 43 INCHES PER MINUTE
  24. 24- CALCULATE METRIC FEEDS AND SPEEDS FOR CNC MILL OR LATHE
  25. 25- CNC MILL PROGRAMMING EXERCISE 1
  26. 26- PROGRAMMING OPEN AND CLOSED ANGLES
  27. 27- CNC MILL EXER 1 PROGRAM REVIEW
  28. 28- CALCULATING RIGHT ANGLE TRIANGLES